Plate Hanger Instructions
For hanging porcelain, china, earthenware, glass plates and unvarnished wood.
Please Follow Carefully.
- Clean the back of the plate by hand, even if the plate is new, using dishwashing liquid. Rinse the plate thorougly and allow it to dry. The plate must be clean so that the DISC bonds properly.
- With your fingers, mix a little water into the glue on the DISC. Leave for 3-7 minutes until the glue is sticky.
- Apply the DISC to the plate making sure that the ring is in the correct position for the plate design. Press firmly and rub well to expel any air. Let it dry overnight.
- Before hanging, test the strength of the adhesion by pulling firmly on the ring. This step will determine that the DISC has properly bonded.
To remove a DISC, soak the plate in warm water. The DISC is designed so that it can be used and removed safely without spooiling the plate's underglaze markings.
The DISC plate hanger also has excellent adhesion to unvarnished wood and hardboard. It is ideal for hanging small pictures and 3D objects of many sizes. The DISC can be trimmed to fit the shape of your unique piece.
The DISC is available in five sizes.
||for plates up to 4" (100mm) diameter
||for plates up to 6 " (150mm) diameter
||for plates up to 8 " (200mm) diameter
||for plates up to 12 " (300mm) diameter
||for plate up to 6.5 lbs. in weight
It is necessary to carefully follow all the directions. Failure to do so will void any warranty, expressed or implied, or responsibility for loss on the part of the manufacturer and distributor.